![]() This is an Internet Standards Track document. This document covers only end-hosts and not tunneling (egress or These functions are out of scope for this document. The mechanisms for determining which remote UDP port number can be To determine whether UDP encapsulation is being used by the peer, nor In particular, it does not provide mechanisms Only those mechanisms for two end-hosts to communicate with each Required within an SCTP stack to add on UDP encapsulation, providing Please note that this document only describes the functionality Implementing it as part of the application without requiring special On hosts without directly accessing the IP layer, for example, This allows the usage of SCTP in networks with legacy This document describes a simple method of encapsulating StreamĬontrol Transmission Protocol (SCTP) packets into UDP packets and its UDP Encapsulation of Stream Control Transmission Protocol (SCTP) Packets Request for Comments: 6951 Muenster Univ. Updated by: 8899 Internet Engineering Task Force (IETF) M. Note: A failing AC adapter can affect any of the LED lights so it’s always a good idea to check the adapter with a voltmeter, especially if the MicroCell is a few years old or you have experienced numerous or unexpected power outages.RFC 6951: UDP Encapsulation of Stream Control Transmission Protocol (SCTP) Packets for End-Host to End-Host Communication We also have comprehensive Video content to help you navigate any issues you might be having: Solid Green – The MicroCell is fully activated and is broadcasting signal.If the MicroCell fails the second location check, please contact AT&T Customer Care. It may also help to relocate the MicroCell to a location with a clear view of the sky. Please power cycle the MicroCell to trigger a new location check. Please ensure the MicroCell is registered to the correct address. Flashing Red – The MicroCell has failed the location check.If the 3G LED continues to flash after 90 minutes, please review the Firewall & Router settings and make sure the modem or router are appropriately configured for use with a MicroCell. Please wait 90 minutes after registration. It is going through activation or is experiencing a connectivity issue. Flashing Green – The MicroCell is not activated.It is either powered off or going through activation. If continued issues occur, it is recommended to not use the Computer Port because of potential issues with the connected computer’s internet settings.Solid Green – No traffic is passing through the MicroCell.Flashing Green – Traffic is passing through the MicroCell.Off – Nothing is plugged into the computer port.Solid Green – The MicroCell has completed the location check.Ĭomputer LED (only on white model MicroCells).It is scanning both for GPS satellites and for local cell sites. Flashing Green – The MicroCell is performing a location check.The MicroCell is either unplugged or is going through activation. Off – No location check is being performed at this time.If the Ethernet LED continues to flash, please ensure DHCP is enabled on the modem or router. Please power cycle the modem, then router, then MicroCell in that order. Flashing Green – The Ethernet cable is connected but the MicroCell has not been assigned a valid IP address.Solid Green – The Ethernet cable is connected and the MicroCell has been assigned a valid IP address. ![]() The MicroCell has been tested and works with Ethernet cables up to 15 feet long. If the LED does not light when both sides are firmly attached, please try an alternate Ethernet cable. ![]() Ethernet cables should click when inserted into an Ethernet port. One side should be plugged into the Ethernet port on the MicroCell and one side should be plugged into an Ethernet port on the modem or router. Please make sure both sides of the Ethernet cable are firmly attached. If not, replace the adapter with one of the exact same power rating. You can also test the ac adapter with a voltmeter. If the LED remains red, please try an alternate power outlet or alternate power cable. Please unplug the MicroCell from power and plug it back in. Solid Red – MicroCell is either still powering up or is in an error state. ![]()
0 Comments
Leave a Reply. |